Peugeot Boxer / Citroën Jumper Uconnect 5″ Radio Nav Monviso TomTom žemėlapių atnaujinimas

Aprašymas

Prepare a USB device

In order to perform a map update, you need a USB device that meets the following requirements:

• The USB device should be empty of any other files or folders.
• The USB device should have at least 8GB free storage space.
• The USB device has a FAT32 file system.
• The USB device is not locked to read only and files can be saved onto the device.

Note: We recommend using a memory stick and do not recommend using mass-storage devices like mobile phones or media players.

To prepare a USB device, do the following:

1. 1. Make sure that the map you want to update is the currently selected and active map in your navigation system. If your navigation system has more than one map and you want to update a map that is not currently active, first make the other map active. To do this, go to the Settings menu and select Switch Map .
   2. Go to the Settings menu and select Navigation Updates .

You are asked if you want to prepare a USB device in order to download updates.

1. 1. Select Yes .
   2. Insert your USB device.

Note: If the system continues to prompt you to insert your USB device, make sure that your USB device meets the above requirements, then try again.

If you connect more than one USB device, the system asks you to remove devices so that only the device you want to prepare is connected.

If there is not enough free space on the USB device, the system asks you to use a different USB device.
If you connect a USB device that contains files, the system warns you that the files on the USB device may be deleted.

The system starts to prepare the USB device.

When the USB device is ready, the message below is shown.

Remove the USB device, connect it to your computer, and send the “ttgo.bif” file by e-mail to carinterfacelt@gmail.com

New USB device, with latest map, will be shipped to your address

Installing the map

Once you have received new USB device, you are ready to install the map to your system.

Note: The map update must be executed with the car engine on and it may take more than 30 minutes. Do not disconnect the USB device during the map install process as it will disrupt the installation.

1. Insert the USB device with the new map into your Uconnect system. The system detects that there is a new map on the USB device.
   Select Start .
   
2. Before the system starts to update the map, you are warned that the update may take some time. Select OK .
   
3. The system starts to update the map.
   Note: Do not remove the USB device or switch off the power to the system before the update is complete. The system cannot be used until the update is completed successfully. If the update is interrupted, start updating the system again.
4. When the map has been updated, the message below is displayed.
   Click Close .
   

The new map is now available on the system.